490-241-0038 Universal Snow Blower Rolling Skid Shoes

490-241-0038 Universal Snow Blower Rolling Skid Shoes

Key Features

• Rolling design allows the snow blower to glide over surfaces, preventing scrapes on pavement, concrete, or pavers.
• Constructed from a durable, non-rusting polymer material for wear resistance and long service life.
• Improves machine handling and maneuverability, especially on uneven or cracked surfaces.
• Kit includes two rolling skid shoes and four mounting washers.

Replaces / Cross-Reference Part Numbers

• 490-241-0038

Compatibility & Fitment

• Fits most 2-stage and 3-stage snow blowers from major brands including MTD, Cub Cadet, and Craftsman.
• Designed for auger housings with bolt center spacing of 2.75 inches and 3 inches.
• Serves as a universal upgrade for standard steel or polymer skid shoes.

When to Replace

• Existing skid shoes are worn thin, cracked, or broken.
• Auger housing or scraper bar makes direct contact with the ground.
• To prevent damage and marks on decorative driveways or garage floors.
• Maneuverability is poor due to worn or incorrect shoes.

Installation Tips

• Position the snow blower on a flat, level surface and disengage the engine. Disconnect the spark plug wire before servicing.
• Adjust the height of both skid shoes evenly to set the scraper bar clearance. A typical setting is 1/8 inch above the surface for smooth pavement.
• Use the included washers as needed for proper spacing and a secure fit.
• Ensure both shoes are at an identical height to prevent the unit from pulling to one side.
• Consult your snow blower's operator manual for manufacturer-specific clearance recommendations.