Logo

AZ00245943

Sold 2,633

Difficulty Icon: Normal
Normal
15 - 20 minutes

$7.65

$8.49

puzzle

Not sure if this is the right part?

Check now

[Lifetime Warranty] Plunger Rubber Gasket Replacement - Compatible with AeroPress Coffee and Espresso Maker - Pack of 2 image 0
[Lifetime Warranty] Plunger Rubber Gasket Replacement - Compatible with AeroPress Coffee and Espresso Maker - Pack of 2 image 1
[Lifetime Warranty] Plunger Rubber Gasket Replacement - Compatible with AeroPress Coffee and Espresso Maker - Pack of 2 image 2
[Lifetime Warranty] Plunger Rubber Gasket Replacement - Compatible with AeroPress Coffee and Espresso Maker - Pack of 2 image 3
[Lifetime Warranty] Plunger Rubber Gasket Replacement - Compatible with AeroPress Coffee and Espresso Maker - Pack of 2 image 4
AZ00245943

[Lifetime Warranty] Plunger Rubber Gasket Replacement - Compatible with AeroPress Coffee and Espresso Maker - Pack of 2

Sold 2,633

Difficulty Icon: Normal
Normal
15 - 20 minutes

$7.65

$8.49

Save $0.84
In Stock

Fast delivery

puzzle

Confirm the fit for your model

Find your model number and check it here to see if the part fits.


Description

Plunger Rubber Gasket - Pack of 2

Key Features

  • Package contains two (2) replacement plunger gaskets.
  • Restores a tight seal to prevent leaks and ensure consistent pressure during brewing.
  • Constructed from durable, food-safe rubber material.
  • Designed as a direct-fit replacement for the original part.

Replaces / Cross-Reference Part Numbers

  • Replaces the original plunger end seal gasket.

Compatibility & Fitment

  • Designed for use with AeroPress Coffee and Espresso Maker models.

When to Replace

  • Loss of pressure or a loose fit when plunging.
  • Coffee leaks past the seal during the brewing process.
  • Visible signs of wear, such as cracking, tearing, or hardening of the original gasket.
  • Plunger slides through the chamber with little to no resistance.

Installation Tips

  • Ensure the coffee maker chamber and plunger are clean and dry.
  • Carefully remove the old, worn gasket from the end of the plunger.
  • Clean the groove on the plunger where the gasket sits.
  • Stretch the new gasket over the end of the plunger until it is fully seated in the groove.
  • Verify the gasket is seated evenly around the plunger before use.