[Lifetime Warranty] S97015162 Fan Motor Assembly for Bathroom Exhaust Fans 8" x 8-1/4" Housing 80CFM 2.5 Sones

S97015162 Bathroom Exhaust Fan Motor & Blower Wheel Assembly

Key Features

• Complete Drop-In Solution:A fully integrated assembly featuring the motor, blower wheel, and metal mounting plate, designed for a direct "plug-and-play" replacement without the need for complex disassembly.
• Optimized 80 CFM Airflow:Engineered to move 80 cubic feet per minute (CFM) of air, providing powerful moisture and odor removal for bathrooms up to 75-80 square feet.
• Balanced 2.5 Sone Rating:Specifically calibrated to balance high-velocity air suction with a moderate sound level, ensuring efficient ventilation during showers and baths.
• Standard 2-Prong Power Plug:Features a factory-installed 2-prong electrical lead that plugs directly into the existing internal housing outlet, eliminating the need for wire splicing or electrical tape.
• Corrosion-Resistant Mounting Plate:The pre-mounted 8" x 8-1/4" metal plate is treated to resist the high-humidity environment of a bathroom, preventing rust and ensuring a stable, vibration-free fit.

Replaces / Cross-Reference Part Numbers

• Primary Part Number:S97015162.
• Verified Cross-References:97015162, 99080486, 99080487, S97012028, S97015161.
• Manufacturer Equivalents:Broan-NuTone S97015162, Nautilus 97015162.
• General Specification:120V, 60Hz, 1.4A, 80 CFM, 2.5 Sones Motor Assembly.

Compatibility & Fitment

• Broan Series:Fits 671R, 672R, 763, 763NC, 763NCT, 763RL, 763RLN, 769R, 769RL, and 769RLN.
• NuTone Series:Compatible with 695, 696N, 696N-R01, and 696N-R02 series exhaust fans.
• Nautilus:Direct fit for many N-series fans utilizing the 8" x 8.25" mounting plate configuration.
• Note:ALWAYSmeasure your existing mounting plate. If your housing is smaller (approx. 7.5" square), you likely need the S97012028 or a similar 50 CFM variant.

When to Replace

• Fan Won't Start:If the switch is on but the motor doesn't hum or spin, the internal thermal fuse or motor windings have likely failed.
• Loud Screeching or Grinding:High-pitched metal noises indicate the motor bearings have dried out or seized due to moisture exposure.
• Excessive Vibration:If the bathroom ceiling shakes when the fan is on, the blower wheel is likely out of balance or the motor shaft has bent.
• Slow Rotation (Low Suction):If the fan spins but doesn't clear the steam from the mirror, the motor is "dragging" and can no longer reach its rated RPM.

Installation Tips

• Safety First:CRITICAL:Turn off the power at the wall switch or breaker. Unplug the old motor from the internal housing outlet before removing any screws.
• The "Slot and Tab" Fit:PRO TIP:This assembly typically slides into a slot on one side and is secured by a single screw or metal tab on the other. Ensure the plate is seated perfectly in the tracks to avoid rattling.
• Clean the Housing:While the motor is out, use a vacuum attachment to clear out the dust, lint, and cobwebs from the discharge duct. This will significantly increase the actual CFM and help the new motor run cooler.
• Blower Wheel Check:Ensure the white plastic blower wheel spins freely by hand before installing. If it rubs against the mounting plate, gently pull it outward on the motor shaft to create clearance.
• Plug Orientation:If the plug feels tight, check for dust inside the housing outlet. A clean connection prevents electrical resistance and potential overheating.